Introducing the FR120N/LR7843/AOD4184 Isolation MOSFET Module Replacement Relay, a high-performance solution for replacing traditional relays in your electronic circuits. This module is specifically designed to provide reliable and efficient electrical isolation, ensuring optimal performance and protection. Equipped with the FR120N, LR7843, or AOD4184 MOSFET transistors, it offers superior switching capabilities with low on-resistance. With a maximum voltage rating of up to 100V and a current handling capacity of 10A, this module can handle a wide range of electrical loads. Say goodbye to mechanical relays that are prone to wear and tear, and embrace the reliability and durability of the FR120N/LR7843/AOD4184 Isolation MOSFET Module Replacement Relay for your electronic projects.
The FR120N/LR7843/AOD4184 Isolation MOSFET Module Replacement Relay is designed with ease of use in mind. Its compact size and easy installation make it suitable for both professionals and hobbyists. With its optically isolated design, this module provides excellent noise immunity and electrical isolation, preventing interference between different circuits. The module features a built-in flyback diode for protecting against voltage spikes when switching off inductive loads. Whether you're upgrading your automation systems, designing motor control circuits, or working on robotics projects, the FR120N/LR7843/AOD4184 Isolation MOSFET Module Replacement Relay offers reliable and efficient switching performance, ensuring the longevity and stability of your electronic systems. Upgrade your relays to MOSFET technology and experience the benefits of enhanced reliability and performance in your circuits.
Specification of FR120N/LR7843/AOD4184 Isolation MOSFET Module:
- with optocoupler isolation, the control signal is isolated from the power supply of the controlled device, which greatly improves the interference.
- compatible with single-chip and Arduino light control board, 3V or 5V signal
- high level start, low level stop, PWM speed
- widely used to control motor start and stop, solenoid valve and other tributary equipment
- the signal input side can solder the terminal block or pin, compatible with breadboard
- the output can be soldered terminals or direct wire bonding
- module size 23mm X 16mm has 2 2mm diameter screw holes, hole spacing 8mm